In order to sustain the duration of the note you need some method of continuously replacing the energy which is being radiated - eg some method of vibrating the tuning fork while it is attached to the resonance box. So increasing the frequency will increase loudness but also decrease the duration of the note.Ĭoating the resonance box might increase the duration of the note but it will also reduce the loudness. According to the article On the acoustics of tuning forks this efficiency is proportional to the 6th power of the frequency. Tuning forks with higher frequency dissipate energy more efficiently. You could also make them larger, but this would probably also make the frequency lower. You’ll find that various frequencies and notes trigger healing in specific areas of the body, which is optimal for best results, whether you use a 440 tuning fork (440 hz or hertz), a low ohm tuning fork, or Fibonacci tuning fork to create the best frequency for your healing session. You could increase the energy stored in the tuning forks by increasing the distance between the tines. Unless you change the tuning fork to make it store more energy, increasing loudness decreases duration, and vice versa. Or it can be dissipated over a shorter time with a louder sound - as when using a larger resonance box. The stored energy can be dissipated over a long time with a quiet sound - this happens when you do not connect it to a resonance box. Once this energy has been dissipated the sound stops. The limitation is set when the tines are touching. There is only so much energy you can put into each tuning fork when you set it vibrating. This is an issue of the conservation of energy. You cannot make the sound both louder and longer without changing the tuning forks to make them store more energy.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |